How To Light A Pilot Light On A Trane Furnace. Set the central furnace thermostat to off or the lowest temperature option. Follow one of the two smaller ones (the large one is for the gas burners) inside the burner compartment.
Depress the button or knob for about 30 seconds. Manufactures heating, ventilating, and air conditioning systems and building management systems and controls. If the ignitor will not glow, it is because:
Table of Contents
As We Mentioned Earlier, Older Model Furnaces Burn Visible Blue Flames.
The pilot light should light, but keep holding the small button down for about a minute. Watch our video on how to get that pil. Set the central furnace thermostat to off or the lowest temperature option.
Received 2,519 Votes On 2,295 Posts.
Once the gas dissipates, turn the knob to “pilot.”. The xe80 furnace is an 80% furnace and you cannot light it manually. The pilot light in a gas furnace is a continuously burning flame that ignites the burners.
Access The Furnace Controls By Opening The Metal Door At The Bottom Front Side Of The Trane Furnace.
While on the “pilot” setting, push and hold down the button or knob. Access the furnace controls by opening the metal door at the bottom front side of the trane furnace. Follow one of the two smaller ones (the large one is for the gas burners) inside the burner compartment.
The Pressure Switch Is Not Making Contact And Allowing Electricity To The Ignitor (Check For Blocked Chimney Or Bad Inducer Motor)
If so, look up your furnace model and number and read the instructions that way. Then light the pilot light in the small hole at the bottom of the oven. If you have a spark igniter, press the ignition button until the pilot flame ignites.
If Your Furnace Has A Blue Flame, It’s Lit By The Pilot Light.
If all systems are working, then you’re ready to try to light the pilot. A thermocouple is an electronic device that monitors the pilot light and shuts off the gas valve to the. Press the small button while you press the electric ignition.